Request for connection to the hub is transmitted for a short time at the time of switching on the device. For the detection and interfacing to occur, the key fob should be located within the coverage area of the wireless network of the hub (at a single protected object). Simultaneously press the button for armed mode (o) and the panic button (!) – the key fob will blink with the central LED. (located inside the body, on the battery fixture and packaging), and select the location room.ģ. Name the device, scan/write manually the QR Code Select the Add Device option in the AJAXapplication.Ģ.
#AJAX SPACECONTROL HOW TO#
How to connect the SpaceControl to the Hub:ġ. Only users with administrative privileges can add the device to the hub. Ensure that the hub is disarmed and does not start updates by checking its status in the mobile application. Switch on the hub and check the internet connection (via Ethernet cable and/or GSM network).Ĥ. Create an account, add the hub to the application, and create at least one room.ģ.
#AJAX SPACECONTROL INSTALL#
Following the hub instruction recommendations, install the AJAX application on your smartphone. In this operation mode, the key fob commands are not delivered to the security system.ġ.
The battery charge level is unacceptably low. Key fobs with firmware version 3.53 and later do not function when the battery charge level is unacceptably low, do not communicate commands to the hub, and do not notify with LED indication In this case, the key fob commands are delivered to the security system.Ĭontinuous short flashes of green light when a key fob with firmware version 3.16 and lower is usedĬontinuous short flashes of red when a key fob with firmware version from 3.18 to 3.52is used After the main indication, the central LED lights up red once and goes out gradually when a key fob with firmware version 3.18 and later is used
#AJAX SPACECONTROL VERIFICATION#
The system has not executed the key fob command - integrity verification is enabled in the system and one of the devices is faultyĪfter the main indication, the central LED lights up green once and gradually goes out when a key fob with firmware version 3.16 and lower is used. The central LED lights up red for approximately half a second when a key fob with firmware version 3.18 and later is used: The system has executed the key fob command The central LED lights up green for approximately half a second when a key fob with firmware version 3.18 and later is used: The central LED lights up green for a few seconds: The key fob has been removed from the security system devices Two LEDs next to the button light up green twice. The command has not been delivered as the security system is too far away and cannot receive the command The central LED lights up red briefly when a key fob with firmware version 3.18 and later is used The LEDs next to the pressed button quickly blink green 4 times when a key fob with firmware version 3.16 and lower is used The key fob command has been sent over to the security system Two green LEDs next to the pressed button light up once: The key fob is not registered with any security system The key fob reports its status only after any button is pressed. Depending on the firmware version, the SpaceControl key fob LEDs indicate the status with red or green light.
0 kommentar(er)
